REGULATIONS IPC

New York Plumbing Code & Permit Rules

NYS Plumbing Code (based on IPC); NYC has separate code (2020)

Data sources: State plumbing boards, ICC, IAPMO, EPA Last verified: 2026-03-16

IPC
Plumbing Code
Required
Annual Backflow Test
No
Homeowner DIY
Yes
Water Heater Permit

Plumbing Code

New York follows the NYS Plumbing Code (based on IPC); NYC has separate code (2020 edition).

NYC has its own plumbing code separate from state

The IPC (International Plumbing Code) is maintained by the International Code Council (ICC) and is adopted by approximately 35 states. It covers water supply, drainage, fixtures, and cross-connection control.

Backflow Prevention Testing

Annual testing is required in New York for testable backflow prevention assemblies (RPZ, DCVA, PVB).

  • Residential: Yes — required for homes with irrigation systems or other cross-connections
  • Who can test: Certified tester
  • Enforcement: NYC DEP strictly enforces; upstate varies
  • Note: Fines + water shutoff for non-compliance

Water Heater Installation

A permit is required to replace or install a water heater in New York.

  • Licensed plumber required: Yes
  • Homeowner can DIY: No — licensed plumber required
  • Note: NYC: only licensed master plumber may pull permit; upstate varies

Universal requirements (all states):

  • Temperature & Pressure Relief (TPR) valve must be installed
  • Discharge pipe from TPR must terminate safely
  • Gas water heaters: proper venting required
  • Minimum 18" clearance from floor for gas heaters in garages
  • Expansion tank often required when backflow preventer is installed on main supply

Homeowner DIY Plumbing Rights

New York requires a licensed plumber for plumbing work. Homeowner DIY is generally not permitted.

NYC: licensed master plumber only; upstate may allow limited homeowner work

Water Conservation Requirements

New York follows federal water conservation minimums (no additional state mandates).

Federal minimums apply

Lead Service Line Replacement

Under the revised EPA Lead and Copper Rule (2021), New York is required to inventory lead service lines and develop replacement plans.

NYC mandatory replacement program; aggressive statewide

Important Disclaimer

This information is provided as a general overview. Plumbing codes and regulations can vary significantly between municipalities within New York. Always check with your local building department before starting any plumbing work. Local codes override state minimums — your city or county may have stricter requirements.

Sources

  • State plumbing boards and licensing agencies
  • International Code Council (ICC) — IPC adoption map
  • International Association of Plumbing and Mechanical Officials (IAPMO) — UPC adoption
  • EPA Safe Drinking Water Act — Cross-Connection Control Program
  • State building departments
Home → Regulations → New York